Where to find cyclops engine fragments12/24/2022 ![]() ![]() The Cyclops can be entered by using the hatch on the keel of the vessel. Vehicles can be docked by approaching the bottom center of the vessel. It will open, allowing a Seamoth or Prawn Suit to be docked inside. The Seamoth or Prawn Suit will recharge while docked, draining power from the Cyclops’ power cells. Vehicles in the Cyclops will also be repaired automatically, if the Cyclops is equipped with a Cyclops Docking Bay Repair Module. When entering the Cyclops through the bottom hatch, the player can use the storage lockers in the keel or climb the ladder to reach the bridge. When entering the Cyclops by docking a vehicle, the player is put into the upper midsection. On the upper front of the vessel (the bridge), the Cyclops can be piloted at the steering wheel. (If you cannot move, make sure your Cyclops is powered and the engine is on) Press the button on the left hand side that looks like a fan in order to enable the engine. I will often refer to all of the sections listed below, so learning them would help! The PDA cannot be accessed while piloting a Cyclops. The keel section is located at the bottom of the Cyclops. It contains five built-in storage lockers and a hatch for the player to embark or disembark the vessel. The ramp section is located beneath the engine room. (I couldn’t get a good picture, but it should be pretty self-explanatory) It has two ladders that lead into the engine room and also has a door that leads to the vehicle bay. The vehicle bay is located in the center of the keel and under the upper midsection. This is where vehicles recharge and are repaired if a cyclops docking bay repair module is used. The upper midsection is located in the central top section of the vessel. The entrances to vehicles can be accessed here, and there is a nearby console used to view/manage the upgrade modules, storage, and health and energy of the docked vehicles. ![]() There is also a module that can be used to insert decoy modules for later use. The engine room is located at the stern of the vessel. There are 3 power cells on each side of the engine. The starboard side is equipped with a cyclops upgrade module fabricator. The port side is equipped with a fire extinguisher and an area used to insert upgrade modules. SUBNAUTICA CYCLOPS ENGINE FRAGMENTS UPGRADE There is also a panel above that which shows the total energy, health, and equipped modules of the Cyclops. The bridge is located on the front part of the vessel. It is accessed from the upper midsection or the ladder located in the front of the keel. Located on the front of the bridge, there is a steering wheel. On the port side of the bridge there is a hologram of the cyclops showing any hull breaches or lava larva that are attached to the hull. Additionally there is a health bar above the hologram. On the starboard side of the bridge there are more controls. There is a panel to customize the colors and name of the Cyclops. ![]() There is also a panel used to enable/disable the lights. The Pilot HUD has most of the main functions of the cyclops. SUBNAUTICA CYCLOPS ENGINE FRAGMENTS UPGRADE. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |